|
|
|
 If it walks like a duck, and talks like a duck could be a very clever animatronics display created by Disney Imagineers.... Sometimes it is just a duck. - IKE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If it walks like a duck, and talks like a duck could be a very clever animatronics display created by Disney Imagineers.... Sometimes it is just a duck. - IKE [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
p2 not working?
We've set our robot to use a single joystick drive, planning to use a seperate joystick (manned by a second operator) to operate our claw/arm/etc... The problem is that the robot doesn't seem to be getting feed from the second joystick.
Do we need to initialize this second joystick somehow, because I don't remember initializing the first one to begin with. (The terminal window that opens after using the IFI Loader only shows the inputs from p1_y, p1_x, p1_trig, and p1_top) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| Gyro not working | 1594code | Programming | 2 | 12-02-2008 18:16 |
| CMUCam not working | Inverted | Programming | 10 | 04-02-2005 19:32 |
| Radios not working... | E Jones 234 | Control System | 3 | 21-01-2005 21:58 |
Threaded Mode