|
|
|
 it's called the Mars Rock automode (you sit there and wait for Opportunity to come along). - EricH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| it's called the Mars Rock automode (you sit there and wait for Opportunity to come along). - EricH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
19-02-2008, 07:10
|
|||
|
|||
|
Re: IR Board Problem
Humm, sorry to hear that. Did you unzip the hex file?
 I didn't have any problems and I used the same file you mentioned. Can you read from the device without error? I wonder if your PC serial port voltage is too low, I saw mention that that could cause problems when I was researching. I guess since it worked for me, I don't have much insight into figuring out what can go wrong. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programing IR board problem | Shivang1923 | Programming | 5 | 16-02-2008 22:55 |
| IR board problem | AmitCarmeli | Electrical | 3 | 09-02-2008 18:53 |
| Another IR Board Problem | C222 | Electrical | 2 | 13-01-2008 17:36 |
| Do you have a problem with the IR Board? | DonRotolo | Control System | 5 | 07-01-2008 23:57 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode