|
|
|
 Take what you have learned, build on it and share it. Others will do the same. Enjoy the journey. - Bertman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Take what you have learned, build on it and share it. Others will do the same. Enjoy the journey. - Bertman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
19-02-2008, 16:44
|
|||
|
|||
|
Re: IR Board Problem
Check out the screen shot in my powerpoint slides. Under the interface tab I selected "JDM (2) for serial port" under Interface Type, and then I loaded the ElCheapo_PCB.ini for the definition file. This was via trial and error before I got "success". Maybe that will help if you didn't do that.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programing IR board problem | Shivang1923 | Programming | 5 | 16-02-2008 22:55 |
| IR board problem | AmitCarmeli | Electrical | 3 | 09-02-2008 18:53 |
| Another IR Board Problem | C222 | Electrical | 2 | 13-01-2008 17:36 |
| Do you have a problem with the IR Board? | DonRotolo | Control System | 5 | 07-01-2008 23:57 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode