|
|
|
 If you see Navy ships in port, you're going to be fine. If you see ships pulling out, or no ships at all, go East. Fast. - Matt Howard [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you see Navy ships in port, you're going to be fine. If you see ships pulling out, or no ships at all, go East. Fast. - Matt Howard [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: CIM motor heatsink
The CIM motors are pretty rugged, I don't think they'll give you a problem.
|
|
#2
20-02-2008, 11:09
|
||||
|
||||
|
Re: CIM motor heatsink
Thank for the advice guys. One thing I forgot to mention is that due to our compact spacing we had to put the compressor right in between our four CIMs, so I think one way or another the out side will get hot no matter what I do. BTW I contested that placement but the team decided against me, so telling me to move the compressor would be mostly pointless.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CIM Motor Differences | Kims Robot | Motors | 2 | 07-02-2008 14:41 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| CIM motor gearbox | tseres | Motors | 3 | 22-05-2007 22:31 |
| dewalt motor VS. CIM motor | John Gutmann | Motors | 12 | 10-01-2007 18:57 |
| No CIM Motor in 2006? | Sscamatt | Rumor Mill | 21 | 22-03-2005 22:47 |
Hybrid Mode
