|
|
|
 No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Turning wires into solids
I made all the wires for inventor using the harness and wiring feature & i want to import all my files into 3ds max, but 3ds max doesn't import them. So is there any way to turn the wires into solids? I tried derived component, but it didnt work. Is there any other way to do this?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two 10AWG wires into one distribution block position | Richard Wallace | Electrical | 7 | 03-02-2008 14:46 |
| turning inputs into outputs | Huron Warriors | Programming | 4 | 19-04-2007 22:10 |
| Turning Capacitors into Batteries. | Ronald_raygun | Electrical | 5 | 12-01-2007 12:32 |
| Turning a gear-tooth sensor into a quadrature output encoder | Jared Russell | Programming | 4 | 18-01-2006 22:19 |
Threaded Mode