|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#13
|
||||
|
||||
|
Re: Operator's Interface: USB Chicklet + Battery
I'm not an electrical engineer, but I would imagine that the higher-voltage battery would supply back-current to the lower-voltage battery, thus charging the lower voltage battery until both are at equilibrium. During this process a bit of charge would be lost due to the battery's internal resistance, but this would be a converging process, not a "domino effect".
Batteries are setup in parallel all the time. I am an RC plane hobbyist and it's done to increase the charge capacity to get a longer flight time. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| USB chicklet | kDude | General Forum | 12 | 17-02-2008 00:58 |
| away around the USB chicklet for using USB Controllers | Stobei | Programming | 2 | 26-01-2008 14:27 |
| USB Chicklet IC12 | whytheheckme | Electrical | 10 | 22-02-2007 07:06 |
| USB Chicklet | SleeveofWizard | Control System | 11 | 28-01-2007 22:45 |
| Gameport to Usb cable vrs. Usb Chicklet | haywirerobotics | Control System | 4 | 25-01-2007 19:03 |