|
|
|
 Holy Orbit ball Batman!!!!!!!!!!:yikes: - yodameister [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Holy Orbit ball Batman!!!!!!!!!!:yikes: - yodameister [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-02-2008, 12:58
|
|||||
|
|||||
|
Re: Using Kevin's PWM outputs for a quieter drive system.
That's usefull information, since with servos, the actual output drive IS directly related to the RC's PWM frequency (many servos use the PWM leading edge to initiate the drive signal)
So that begs the question....: What is the PWM Output frequency of a Victor? and: Why does my transmission sound so cruncy at low power. The noise starts well before the GBox's output shaft starts moving, so I assume it's an oscillation detectable at the motot's output shaft. Phil. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with PWM outputs on RC | Adam Richards | Control System | 1 | 20-02-2007 06:37 |
| Using kevin's code for driving and camera tracking | razzoc | Programming | 3 | 18-02-2007 08:50 |
| What drive system is your team using? | dpick1055 | Technical Discussion | 22 | 27-01-2007 23:29 |
| Using 6 motors in a drive system? | FIRST JerseyKid | Motors | 7 | 12-01-2005 23:49 |
| relay and pwm outputs | nick_champ_2 | Electrical | 1 | 31-01-2003 13:08 |
Threaded Mode