|
Re: Eliminating a few other things...
Posted by Travis Covington.
Student on team #115, MV ROBOTICS, from Monta Vista High School and Hitachi Data Systems - 3com - NASA Ames.
Posted on 4/2/2000 3:59 PM MST
In Reply to: Re: Eliminating a few other things... posted by Jerry Eckert on 4/2/2000 3:32 PM MST:
: Is the motor on the bad side running significantly
hotter than the opposite side?
Not really. As soon as we install a new one it seems
to be fine. The are equally warm (not hot). But after
we have it out on the floor under some load the current
draw just sky rockets, and the motor is shot. We are
pretty sure that it is not a problem w/ side loads or
too much friction.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
I think with so many facets of FIRST, success comes from learning the true meaning of teamwork through working towards a common goal. - Kristina [more] 
23-06-2002, 22:39
Threaded Mode