|
|
|
 An FRC team's success should not be measured in how many robots it can build or how many blue banners it can collect. It should be measured by how many engineers (and other professionals) it 'builds'. - jvriezen [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
26-02-2008, 19:07
|
|||
|
|||
|
Re: Banebots 42MM 36:1 Gearbox Ratios
Kyle:
Your team has produced an innovative design, and I'm sure you all will find a viable solution if sideloading is the root cause (as Adam's insight supports). I'm sure you've seen the bearing blocks offered by Banebots for these gearboxes. We are using the smaller version (3/8 shaft) for our ladder sprockets, and are pleased with the quality of their construction. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebots 42mm gearbox: Recommendations for use | Joe Johnson | Motors | 61 | 01-04-2007 15:28 |
| REQUEST: Banebots 42mm 256:1 at LoneStar | Kevin Sevcik | Motors | 0 | 27-03-2007 22:07 |
| Banebots 42mm grease? | Kevin Sevcik | Motors | 2 | 23-03-2007 19:23 |
| BaneBots 42mm Gearbox Pinion | Gary Bonner | Motors | 1 | 31-01-2007 13:44 |
| Drill Motor Gearbox Reduction Ratios | archiver | 2000 | 3 | 23-06-2002 23:05 |
Threaded Mode