|
|
|
 Yes, machining a dog profile into a steel sprocket on a manual mill was an experience filled with pain and regret. - Joe G. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yes, machining a dog profile into a steel sprocket on a manual mill was an experience filled with pain and regret. - Joe G. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
27-02-2008, 00:42
|
|||
|
|||
|
Re: When Did You Finish Your Robot
Whats this "finish" you keep saying?
On their own, all of our systems work, and we've narrowed our pre-ship problems down to faulty wiring on our OI board, should be a quick fix Thursday at SV, then we should be good to go. I do have to say though, we've finished more of the robot before shipping then we have in past years Ive been on the team. Last edited by laultima : 27-02-2008 at 01:25. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SHIP DAY IS HERE!!! Did you finish??? | sgsdragons | General Forum | 50 | 19-02-2008 11:52 |
| When did you finish your robot? (if at all :) | Leav | General Forum | 34 | 16-02-2006 13:21 |
| When did you get your kit? | NextPerception | Kit & Additional Hardware | 3 | 18-01-2006 21:12 |
| When Did You Have Your First Accident? | Dorienne | Chit-Chat | 44 | 17-11-2004 21:32 |
| Where did you build your robot? | Summmergrl2298 | Chit-Chat | 25 | 13-04-2002 15:30 |
Threaded Mode