|
|
|
 Is CAD essential to all teams?
No, but neither are power tools. - 346CADmen [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Is CAD essential to all teams?
No, but neither are power tools. - 346CADmen [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: My gyro is acting very strangely
Try spinning the gyro randomly for 30 seconds and see if it still ends up at the same value after 30 seconds. If so you have a bad cable/connection/chip/SW setup.
If that works the way you expect it to its probably a calibration issue. Remember, your integration is only as good as the error you can hold with original signal. We've never had any issues with the gyro driver and calibration routine found on www.kevin.org/frc . I suggest you try this if all else fails. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SMC single acting solenoid | Sam2197 | Pneumatics | 1 | 24-01-2008 00:18 |
| Help my 3DS is acting screwy! | BuddyB309 | 3D Animation and Competition | 1 | 16-01-2006 09:43 |
| Span/Div tags acting funky | Mike | Website Design/Showcase | 9 | 29-05-2005 16:23 |
| Printf acting flaky | steven114 | Programming | 7 | 20-02-2005 19:20 |
| optical sensors acting strangely | rosebud | Electrical | 10 | 03-02-2003 00:29 |
Hybrid Mode
