|
|
|
 ...next years game will hopefully make my head hurt, this years did. - Michael Leicht [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...next years game will hopefully make my head hurt, this years did. - Michael Leicht [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
RC Analog Pins not working
So before we shipped our 2008 bot to wherever it goes, we noticed that our all-to-important gyro and ultrasonic sensors would not read when plugged into the controller on that bot.
We ran tests, we used different sensors, and nothing worked. We then put the sensor on another board (the 2007 board, same code) and it worked fine. we are wondering if something is wrong with our controller, and if we should even bother trying to fix it at the regional tomorrow. help? has anyone seen this problem before? Last edited by Uberbots : 11-03-2008 at 23:00. Reason: emphasis with a capital E |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| pulsing digital out pins, not as fast as pwms | Generalx5 | Programming | 5 | 02-04-2007 18:52 |
| pic: Pins Pins and more pins | CD47-Bot | Extra Discussion | 26 | 04-09-2005 23:07 |
| Why not analog sensors?? | gnormhurst | Programming | 16 | 07-03-2004 16:14 |
| Drill Motors: Pins IN or Pins OUT | Caleb Fulton | Motors | 28 | 03-02-2003 14:19 |
Threaded Mode