|
|
|
 Wait...you're supposed to have a driver? I guess I should have read past the Autonomous section in the manual :D - ASD20 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Wait...you're supposed to have a driver? I guess I should have read past the Autonomous section in the manual :D - ASD20 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
11-03-2008, 23:34
|
|||||
|
|||||
|
Re: RC Analog Pins not working
We found a few 2008 RC loaded with Version 13 code in Chicago. If your code cannot run on V13 then that might be the problem. To check, tether up and power the robot. Press the button underneath the team numbers on your OI to cycle through the readout and you will get to a display that starts with a v followed by two numbers. It should be v15 but if it is v13 you will have to reload the firmware and then your software. Just a possible solution...
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| pulsing digital out pins, not as fast as pwms | Generalx5 | Programming | 5 | 02-04-2007 18:52 |
| pic: Pins Pins and more pins | CD47-Bot | Extra Discussion | 26 | 04-09-2005 23:07 |
| Why not analog sensors?? | gnormhurst | Programming | 16 | 07-03-2004 16:14 |
| Drill Motors: Pins IN or Pins OUT | Caleb Fulton | Motors | 28 | 03-02-2003 14:19 |
Threaded Mode