|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
|||||
|
|||||
|
Re: IR board improvement
Mike.
I agree that a diode across the regulator with the cathode at V in is appropriate with a larger output capacitor. Not sure if that needs to be the case here. However, I would recommend a 10 mfd near the chip just to protect against transients when the LEDs turn on. I like the use of the RC 5 volt rail but the you should then keep the big cap in place to filter the power. One team at Boilermaker had a short on the board pull down the RC 5 volts. Perhaps a small fuse is in order as well. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FVC]: Analysis Shows Improvement Possible in Ranking System | billw | FIRST Tech Challenge | 24 | 05-07-2007 01:35 |
| White Paper Discuss: Continuous Improvement - 2005 Championship Forum Presp | Chris Fultz | Extra Discussion | 0 | 25-04-2005 12:55 |
| Forum Improvement (Team Searching) | Cyberguy34000 | CD Forum Support | 4 | 16-01-2005 19:27 |
| A Simple Improvement to Driving | generalbrando | Programming | 16 | 01-01-2005 15:32 |
| [OCCRA]: Rule GR4.1 improvement | Mike Martus | OCCRA Q&A | 0 | 13-09-2004 21:00 |