|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
|
|||||
|
|||||
|
Re: how does one go about making a 6 wheel config drivetrain?
Well, the simplest way is the KOP frame. If using KOP wheels (you'll need 6 of them obviously). Put four at the ends like you normally would. There is a hole that is slightly lowered in the center of the frame that you should use for your middle wheel.
It is lowered to relieve the pressure from the corner wheels so you can turn easier. The easiest way to run chain is with the center wheel having two sprockets and the ends having 1. http://andyburchardt.com/robotics_re...0Drive%201.jpg |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1519 - One Dual-Config Robot or Two Robots? | Ken Streeter | General Forum | 127 | 12-03-2008 15:26 |
| What do you think about how easy theyre making programming? | Leav | Programming | 76 | 11-01-2005 12:07 |
| How does one become a ref? | minic@HYPER69 | General Forum | 11 | 05-05-2004 01:08 |
| How does one go about ordering more motors... | Team852 | General Forum | 3 | 27-01-2003 14:37 |
| How Do I Program My RC To Spot One wheel From Going faster than the other | Kyle1010 | Programming | 5 | 12-01-2003 15:30 |