|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
Re: cilinder issues (big trouble)
Re-analyze the rules as much as possible -- if they're exactly what the rules specify then you should be ok and need to appeal the inspection somehow. Be sure to include rule updates and a bit of Q&A in your research.
If your cyllinders fall within any gray area or you didn't go through the exact vendors specified in the pneumatics manual (even though the rules state you MUST use those vendors) then this is a tough lesson. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BIg Bad Bob's Big Bad Claw | Ty Tremblay | General Forum | 0 | 24-02-2008 18:05 |
| Inventor software trouble/ FIRST Base trouble | nasa-senpai | General Forum | 2 | 24-01-2007 09:15 |
| Big Big Problem | Ronald_raygun | Fundraising | 23 | 04-10-2005 01:03 |
| [moderated]: 2005s big issues - post solutions (and a little rant on the side) | Daniel Brim | General Forum | 1 | 30-03-2005 21:36 |
| trouble... | archiver | 2001 | 0 | 24-06-2002 01:39 |