|
|
|
 The teams who have the best chance at success are the ones who know where they can save time and money on machining by using or using part of some premade equivalent.
- Bill Gold [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
20-03-2008, 11:35
|
|||
|
|||
|
Re: cilinder issues (big trouble)
Remember also that you can't use any bore size you feel like. Only 3/4", 1-1/2", and 2" are allowed. This is a common source of confusion with pistons.
Also, didn’t the inspectors tell you why they weren’t allowed? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BIg Bad Bob's Big Bad Claw | Ty Tremblay | General Forum | 0 | 24-02-2008 18:05 |
| Inventor software trouble/ FIRST Base trouble | nasa-senpai | General Forum | 2 | 24-01-2007 09:15 |
| Big Big Problem | Ronald_raygun | Fundraising | 23 | 04-10-2005 01:03 |
| [moderated]: 2005s big issues - post solutions (and a little rant on the side) | Daniel Brim | General Forum | 1 | 30-03-2005 21:36 |
| trouble... | archiver | 2001 | 0 | 24-06-2002 01:39 |
Threaded Mode