|
|
|
 Playing fields outdoors in the snow and the only field faults were when you ran out of gas!...ahh the old days - ExTexan [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Playing fields outdoors in the snow and the only field faults were when you ran out of gas!...ahh the old days - ExTexan [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
20-03-2008, 12:26
|
|||||
|
|||||
|
Re: Flag holder
See this on Nominal Pipe Size: http://en.wikipedia.org/wiki/Nominal_Pipe_Size
Another source http://www.harvel.com/pipepvc-sch40-80-dim.asp says that the dimensions are .84" od and .6" id. The key thing to remember is that on a 1/2" nominal schedule 40 PVC, there will be no measurement of .500 inches. Although the rules say that you may use holes for mounting, you can't put a connector through the interior of the tube. This is because the flag pole itself is wrapped in tape to keep it in place better. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flag, Flag Holder vs Trackballs | Swampdude | Rules/Strategy | 29 | 09-03-2008 09:17 |
| Flag Holder (?) | Spiders | Technical Discussion | 8 | 24-02-2008 16:48 |
| Flag Holder Mounts | RoboGeek99 | General Forum | 10 | 17-02-2008 19:32 |
| Flag Holder info | Magnechu | Kit & Additional Hardware | 4 | 13-02-2008 19:08 |
| Flag holder caps. | General Thunder | Rules/Strategy | 10 | 28-03-2007 15:00 |
(since 2004)
Threaded Mode