Autonomous Controller Board Switch

Alan Anderson · #1 24-03-2008, 23:05

Quote:

Originally Posted by starsROBOTICS

how do i figure out which pins are which. do i read it from left to right starting at the top or do i read up down up down?

The pin numbers are usually marked on the connector. They go 1-8 across the longer row, then 9-15 in the same direction across the shorter row.

lilBcos · #2 25-03-2008, 08:04

we use the AndyMark manufactured one and it works very well

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Autonomous Controller Board Switch	merybar	General Forum	2	27-01-2008 12:54
Cool Controller Board	jacobevelyn	Control System	3	26-01-2008 13:13
pic: Autonomous Mode Switch	Gary Bonner	Robot Showcase	4	18-02-2005 21:58
Using a switch before autonomous operation	KZos550	Programming	11	04-02-2003 19:12
Autonomous Kill Switch	UCGL_Guy	Programming	8	15-01-2003 17:39