|
|
|
 I believe in my students, I encourage them to fail in their endeavors to find the best formula. There is valuation in failure. - Chief Hedgehog [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I believe in my students, I encourage them to fail in their endeavors to find the best formula. There is valuation in failure. - Chief Hedgehog [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
25-03-2008, 15:23
|
||||
|
||||
|
Re: Drivetrains - How are you doing it?
You were close. We use 2 CIMs coupled into one dewalt per side. This direct drives our middle wheel, and we have chain running from there to our front and back wheels (6WD). We use AndyMark off the shelf 6" wheels and the middle one is lowered about an eigth inch for turning. We also use servo shifting. Our problem has been our drive shaft breaking. It happened in the quarters and semis at detroit, thank goodness for 47 and 453 winning one on their own. We have a plan to fix this for GLR and hope to be working much better.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How Are The Rookies Doing | Justin1636 | General Forum | 3 | 28-03-2005 00:40 |
| What Motors/Drivetrains are YOU using? | IA-Howitzer | Motors | 16 | 27-02-2005 15:01 |
| Registration Open - How are we doing? | Andrew | General Forum | 83 | 06-01-2004 13:22 |
| How are your Drivers and Human players doing????????? | archiver | 2001 | 2 | 24-06-2002 00:33 |
| how are the teams doing so far? | archiver | 2001 | 7 | 23-06-2002 23:37 |
Threaded Mode