|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Quick question, the serial port on the CMU camera is made only to test the camera not to connect to the Robot Control, correct?
please help, anything. yes I sound stupid for not knowing this. Last edited by kevin : 18-02-2008 at 11:14. |
|
#2
|
||||
|
||||
|
Re: CMU Camera
Quote:
It has a DB-9 serial interface, and a TTL serial interface. They are infact one. That's why you MUST unconnect the TTL serial when you program or look at the screen captures using the DB-9 port. Then when done connect the TTL serial interface back up. You CAN in theory connect the DB-9 port of the camera to the DB-9 port of the robot controller. Couple of things...If you have ANY PRINTF's you'll need to turn them off or reconfigure your RC to printF to another port, like the TTL serial port. Also you'll have to configure the camera driver to read from the DB-9 port on the RC instead of the TTL serial port. Generally, most people I assume use a PWM cable, TTL board to connect the camera, then HOT GLUE the crap out of the TTL PWM cable end at the camera and hot glue the TTL board down at the RC end....at least that's what we do. |
|
#3
|
|||||
|
|||||
|
Re: CMU Camera
I count THREE serial "connections" on the CMUCAM
![]() |
|
#4
|
|||
|
|||
|
Re: CMU Camera
how do i get the camera to show me live feed from the robot to the monitor? i havent connected the camera to a monitor yet
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CMU Camera Mount | RyanCahoon | Kit & Additional Hardware | 3 | 20-02-2008 11:08 |
| Tell the difference: 2007 CMU Camera, 2006, 2005 camera? | Chris_Elston | Programming | 2 | 07-01-2008 13:11 |
| CMU camera 2006 | canadude | Programming | 2 | 27-05-2006 14:25 |
| CMU camera search | Windward | Programming | 14 | 18-01-2006 19:21 |
| CMU Camera Tracking | auditt241 | Programming | 0 | 03-02-2005 16:33 |