|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
Re: Advice needed !!
Did you lower the center wheels of your robot? Most 6-wheel designs include a dropped center wheel to facilitate turning (the robot is never on more than 4 wheels and will turn on the center two).
Another no-brainer check is to make sure that you have 40A breakers and not 20 or 30A breakers pluged in line with the motors. Also, make sure that your gearboxes are properly lubricated and that there is as little resisitance in them as possible. That's all I can think of right now: Good luck! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice needed for monitoring child's internet usage | Andy Baker | Chit-Chat | 16 | 29-05-2007 20:33 |
| Advice needed for drive system! | Chernicki | General Forum | 5 | 18-01-2007 14:09 |
| ADC advice needed | Josh Siegel | Electrical | 9 | 18-10-2006 23:39 |
| Welder advice needed | Rickertsen2 | Technical Discussion | 15 | 09-01-2006 16:26 |
| Expert advice needed!!! | punarhero | Technical Discussion | 16 | 01-03-2004 11:34 |