|
|
|
 Long Live Gracious Professionalism, and long live F.I.R.S.T. - Matt Krass [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Long Live Gracious Professionalism, and long live F.I.R.S.T. - Matt Krass [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
02-04-2008, 11:31
|
|||||
|
|||||
|
Re: IR Board Programming/Wiring Problems
Back to one of Alan's original questions.
Describe to us the power source and how the power is wired up to your IR receiver. Your description reflects what you'd see if the IR receiver were powered, say from a separate 9v battery or other source that isn't the same source of power that the Robot Controller uses (12v battery). or If command 3 is always high that would probably just be a bad connection. Last edited by Mark McLeod : 02-04-2008 at 11:36. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Electronics Board Wiring Concern | SpaceOsc | Electrical | 7 | 13-02-2008 12:15 |
| Wiring The IR Board | joesmomh00haha | Sensors | 2 | 12-02-2008 15:30 |
| IR board wiring | Brandon_L | Electrical | 1 | 11-02-2008 15:14 |
| Wiring IR board | DarKCroNo | Sensors | 3 | 09-02-2008 10:20 |
| Wiring the IR sensor board | govvijay | Programming | 9 | 05-02-2008 19:41 |
Threaded Mode