|
|
|
 Test your code and your assumptions. - ShotgunNinja [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Test your code and your assumptions. - ShotgunNinja [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
03-04-2008, 14:57
|
||||
|
||||
|
Re: MK Battery Problems
Two of our batteries have issues similar to this.
We put the battery in the robot, switched it on, and nothing happened. The robot didn't go on at all. We disconnected the Anderson connector and connected a different battery without actually moving the first one, switched it on and it was fine. I think it was the battery, but after reading the thread I now suspect the Anderson connector as well. It has happened to us only a few times and each time, we haven't done a thorough investigation of the problem. I believe we have a mix of new and old Anderson connectors on the batteries (we taken them off old, dead ones). |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Battery Terminal problems | Zack Briggs | Electrical | 11 | 05-03-2008 12:14 |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| Battery to RC problems | hedgehogger | Control System | 1 | 28-01-2005 16:26 |
| Battery To RC PROBLEMS | hedgehogger | Control System | 1 | 26-01-2005 18:43 |
| Battery Charger for long term battery care | DougHogg | Kit & Additional Hardware | 0 | 08-02-2003 15:25 |
Threaded Mode