|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||
|
||||
|
Re: Serial data out of the programming port
Doug,
I'm not sure if a wait commend via flow control will effect the RC and cause it to stall. I feel that it is very unlikely, and that RC just ignores any type of flow control. But, to be sure if I was in you situation I would build a serial cable with only ground and RX pins connected on the logger end. This would assure that you logger isn't effecting the RC it wouldn't be able to send any data back to the RC. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does reading from the serial port work? | Alan Anderson | Programming | 16 | 29-01-2008 07:15 |
| Programming the vex microcontroller to respond to commands on the serial port | crashoverride02 | Programming | 1 | 20-10-2006 14:17 |
| Programming Vex Starter Kit To Recieve From Serial Port | firetrap | FIRST Tech Challenge | 0 | 26-09-2005 17:27 |
| TTL port to a serial port on a demo board | ImmortalAres | Programming | 16 | 09-07-2005 23:44 |
| Serial Port Programming | phrontist | General Forum | 1 | 07-02-2004 16:13 |