|
|
|
 That is definitely a question for the GDC. My guess would be no (but I am frequently wrong). - Mike Betts [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| That is definitely a question for the GDC. My guess would be no (but I am frequently wrong). - Mike Betts [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
08-04-2008, 19:59
|
|||
|
|||
|
Re: IR Board Programming/Wiring Problems
The way this little guy is supposed to be wired is one (IR board) output going to one (RC) input. That means that instead of connecting three wires to one "PWM" cable, you must use four PWM cables and connect each of the outputs to one yellow/white cable.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Electronics Board Wiring Concern | SpaceOsc | Electrical | 7 | 13-02-2008 12:15 |
| Wiring The IR Board | joesmomh00haha | Sensors | 2 | 12-02-2008 15:30 |
| IR board wiring | Brandon_L | Electrical | 1 | 11-02-2008 15:14 |
| Wiring IR board | DarKCroNo | Sensors | 3 | 09-02-2008 10:20 |
| Wiring the IR sensor board | govvijay | Programming | 9 | 05-02-2008 19:41 |
Threaded Mode