|
Possible changes...
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.
Posted on 10/18/2000 11:59 AM MST
In Reply to: Material list suggestion posted by Philip on 10/18/2000 11:21 AM MST:
Attention all,
We have my mistake and/or poor planning left off some things we had intended to include or should have included on the Additional Hardware List.
We will publish an officially updated list soon, but before we do, we would like your input.
Please review the following changes comment as you feel necessary.
Joe J.
Adding to the Additional Hardware List:
-Schedule 40 PVC Pipe up to 2 1/4 inch (Nominal Dimension)
-#35 Steel Roller Chain
-#35 Standard Connecting Links
-Steel Springs (torsion, compression or extension) -- 'Off the shelf' & avalilable from typical hardware stores
For reference, any spring from McMaster-Carr on pages 3186 thru 3201 (Cat. #106) inclusive meets the definition of an acceptable off the shelf spring -- in fact you may purchase them from McMaster if you like. You can view the pages online by following the link below to McMaster.com and entering the page number you desire into the field in the upper left corner. Good luck. JJ
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Yes, you are correct. Even when all other databuses are totally out of bandwith, the PainInTheCalf Bus gets top priority. Good thinking ;-) - Joe Johnson [more] 
Similar Threads
Hybrid Mode
