Globe Motor - Chief Delphi

24-06-2002, 00:15

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Globe Motor

Posted by Artur.

Other from International Academy.

Posted on 10/26/2000 6:39 PM MST

In the Application Notes, it is stated that the shaft of the Globe motors is not suitable for anything not listed in the interface list. I was wondering if this included 'home-made' devices not directly from the Kit of Parts. The Kit includes only two devices that can handle the torque of Globe motors, but there are four motors.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Globe Motor	archiver	2000	4	24-06-2002 00:15
So you want to stall a Globe Motor...	archiver	2000	1	24-06-2002 00:09
Globe Motor and Thermal Protection	archiver	1999	0	23-06-2002 22:03
Globe motor, anyone?	archiver	1999	3	23-06-2002 21:59
Help! Need a Globe Motor	Dodd	Motors	0	24-07-2001 11:57

All times are GMT -5. The time now is 21:43.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.