|
|
|
 Will.I.Am is not FIRST. - BrendanB [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Will.I.Am is not FIRST. - BrendanB [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
15-04-2008, 10:58
|
|||||
|
|||||
|
Re: Drive wheel motors using OItoPWM() --- how to debug?
Use the OI Analog Input block, and throw that to a variable (int should be fine.) Then you can print out that variable, and see what it is.
Jacob |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to get robot to drive straigth using shaft encoders | eccmaster | Programming | 5 | 02-02-2008 23:50 |
| Four Wheel Drive Using Standard Transmissions | daviamp | Technical Discussion | 4 | 18-01-2006 20:03 |
| Using 6 motors in a drive system? | FIRST JerseyKid | Motors | 7 | 12-01-2005 23:49 |
| How many motors are you using to drive? | Joseph F | Motors | 18 | 16-10-2002 21:24 |
Threaded Mode