|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: 2002 CIM specs
Jeff-
We used to wire EDM a profile that would fit onto the "spline" in order to install a gear on that shaft. That would not take up too much space. Ken |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AndyMark CIM Planetary Gearbox Torque Specs Needed | KTorak | Technical Discussion | 4 | 17-01-2008 18:53 |
| Large CIM specs? | Xarda | Motors | 1 | 31-01-2007 23:07 |
| Small CIM Gear Specs | Joe_Widen | Technical Discussion | 2 | 03-04-2006 23:10 |
| Large CIM motor specs | ryan_f | Motors | 4 | 13-01-2006 21:38 |
| Drill and CIM specs | BlacKnight6604 | Motors | 1 | 13-01-2004 09:52 |