|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
Re: How much torque can the Dewalt Trannies take?
Perhaps Dennis from Team 27 could shed some light.
I think they found the limit this year, as Team 27 Team Rush was replacing Dewalt trannys after a few matches due to a catastrophic failure of some part in the system. Maybe Den could figure out what type of load and torque they were seeing and let everyone know what the the limit is. Mike |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much of our wheel used for the shooter can be exposed? | waialua359 | Technical Discussion | 4 | 14-02-2006 13:27 |
| Servos - How much can they lift? | John JediMaster | Electrical | 23 | 31-01-2004 19:03 |
| how much is too much on the DRILL MOTORS? | archiver | 2001 | 11 | 23-06-2002 23:53 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |
| How much code can an IFI controller handle? | Larry Barello | Programming | 7 | 10-02-2002 19:06 |