|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||
|
||||
|
Re: How much torque can the Dewalt Trannies take?
I'm not necessarily the best person on this subject but as far as I know we don't have any real numbers on the limit of the dewalts. Though the failures appeared to have similar simptoms, we managed to cause a different failure almost every time. This was running two cims through the dewalts on a 6 traction wheel drive (6 inch andymarks) with the center wheels dropped.
edit: originally we did break a few drive shafts but then we managed to chase the failures into the transmissions themselves Last edited by Josh Fox : 30-04-2008 at 16:28. Reason: further input and spelling, grammar and such |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much of our wheel used for the shooter can be exposed? | waialua359 | Technical Discussion | 4 | 14-02-2006 13:27 |
| Servos - How much can they lift? | John JediMaster | Electrical | 23 | 31-01-2004 19:03 |
| how much is too much on the DRILL MOTORS? | archiver | 2001 | 11 | 23-06-2002 23:53 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |
| How much code can an IFI controller handle? | Larry Barello | Programming | 7 | 10-02-2002 19:06 |