|
|
|
 Hmmm I think I hear phones ringing. Panic calls to the Rules committee to figure out how to close THAT loophole, which you could drive a truck through. Have you considered a career in Law? - ChrisH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#26
02-05-2008, 13:30
|
||||
|
||||
|
Re: How much torque can the Dewalt Trannies take?
Could you post up pictures of that transmission (188). That post is very informative and it is starting to confirm my belief that if at all possible we should try to use a custom dog shifting transmission, especially if cost is relatively close (within $100 per transmission).
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much of our wheel used for the shooter can be exposed? | waialua359 | Technical Discussion | 4 | 14-02-2006 13:27 |
| Servos - How much can they lift? | John JediMaster | Electrical | 23 | 31-01-2004 19:03 |
| how much is too much on the DRILL MOTORS? | archiver | 2001 | 11 | 23-06-2002 23:53 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |
| How much code can an IFI controller handle? | Larry Barello | Programming | 7 | 10-02-2002 19:06 |
Threaded Mode