pic: Roccobot 2k8

[ducttapedude]

Originally Posted by Mike Nawrot

Wow. I'm a bit surprised that 1/16" 6061 held up in such a high impact area. Especially with all that material cut out. Our drivers managed to bend a piece of 3/16" 6061 with a mild cheesing pattern in the same area this year. Glad that worked out for you guys though.

O, and your machines are always incredible works of engineering. I look forward to seeing them every year.

There were bumpers covering all sides so the only thing it came into direct contact with were those metal blocks at the ends of the divider on the playing field.

[Mike Nawrot]

Originally Posted by ducttapedude

There were bumpers covering all sides so the only thing it came into direct contact with were those metal blocks at the ends of the divider on the playing field.

That makes sense. The side we damaged was the one side that didn't have a bumper (it would have interfered with ball pickup).

[ducttapedude]

Originally Posted by Mike Nawrot

That makes sense. The side we damaged was the one side that didn't have a bumper (it would have interfered with ball pickup).

Yeah, the bumpers do make a huge difference in what you can put where and still keep it rigid.

We also had a small, probably....6-8inch gab in the front of our bumpers for our manipulator.

[Brandon Holley]

Originally Posted by ducttapedude

Yeah, the bumpers do make a huge difference in what you can put where and still keep it rigid.

We also had a small, probably....6-8inch gab in the front of our bumpers for our manipulator.

The bumpers definitely have a huge effect.

We ran the scrimmage in CT without bumpers and it left our robot with several dents and dings down the sides.

[=Martin=Taylor=]

What was the maximum speed?

[ducttapedude]

Originally Posted by Hachiban VIII

What was the maximum speed?

It ran around 12-12.5 ft/s.