|
|
|
 FRC is about what we collectively make of it. - Tristan Lall [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| FRC is about what we collectively make of it. - Tristan Lall [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#11
07-05-2008, 18:27
|
||||
|
||||
|
Re: .ipt to dxf? to CNC machines?
I would look here
http://www.chiefdelphi.com/forums/sh...ad.php?t=59985 and http://www.chiefdelphi.com/forums/sh...ad.php?t=28982 Last edited by Jeff 801 : 07-05-2008 at 18:30. Reason: more info 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intelitek CNC Motion - Virtual CNC Machines | Kingofl337 | Programming | 0 | 19-03-2008 11:29 |
| CNC Machines | DEAL234 | Technical Discussion | 17 | 07-02-2007 16:30 |
| What machines are you using? (CNC, lathes, mills, 3-in-1 machines?) | MrB | Technical Discussion | 17 | 03-11-2006 11:55 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |
| Inventor (*.ipt) -> Dxf | patTeam241 | Inventor | 5 | 16-02-2004 23:09 |
Threaded Mode