|
|
|
 You want to be treated like a professional, so you need to continue to act like one even if the odds are against you. - Eugenia Gabrielov [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| You want to be treated like a professional, so you need to continue to act like one even if the odds are against you. - Eugenia Gabrielov [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#14
09-05-2008, 13:12
|
||||
|
||||
|
Re: .ipt to dxf? to CNC machines?
Heres a look at the right side bracket. its not completely finished...75% done.
See attached pictures. Thats a 12" x 5" base with a motor mount on the circular portion of it, and a support bracket on the other end. Last edited by Generalx5 : 09-05-2008 at 13:15. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intelitek CNC Motion - Virtual CNC Machines | Kingofl337 | Programming | 0 | 19-03-2008 11:29 |
| CNC Machines | DEAL234 | Technical Discussion | 17 | 07-02-2007 16:30 |
| What machines are you using? (CNC, lathes, mills, 3-in-1 machines?) | MrB | Technical Discussion | 17 | 03-11-2006 11:55 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |
| Inventor (*.ipt) -> Dxf | patTeam241 | Inventor | 5 | 16-02-2004 23:09 |
Threaded Mode