|
|
|
 Although I have much yet to go, in my short time in FIRST I have learned there is no such thing as a waste of time, especially when a) fundraising, b) mentoring students, or c) reading directions.
- Amanda Morrison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
22-05-2008, 18:34
|
||||||
|
||||||
|
Re: How do you put 2 CIM motors into a Dewalt transmission?
Think careful about this one. I know of a team that did this last year and had many transmission failures. The XRP trans is just not strong enough.
There is a stronger Trans from Dewalt on their bigger drill...... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| pic: How do you put an encoder on the FP Gearbox? | JVN | Technical Discussion | 14 | 19-02-2007 22:00 |
| pic: Version 2 of the 2 CIM into 1 DeWalt gearbox | MAteo9944 | Extra Discussion | 3 | 21-01-2007 13:00 |
| How many CIM motors can we use? | lucky | Motors | 4 | 19-01-2006 18:30 |
| How much time do you put into building your robot | Wayne Doenges | General Forum | 16 | 29-01-2002 19:30 |
Threaded Mode