|
|
|
 How about "Lebron"? Wait, no, you'll be dooming yourselves to failure the last 30 seconds of every match. - Travis Hoffman [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| How about "Lebron"? Wait, no, you'll be dooming yourselves to failure the last 30 seconds of every match. - Travis Hoffman [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
Re: How do you put 2 CIM motors into a Dewalt transmission?
you could try something similar to the robonauts' V6 from 2006 just design it for 2 cims instead of 4
attached is a cad of one that i have been working on |
|
#17
26-05-2008, 13:15
|
|||||
|
|||||
|
Re: How do you put 2 CIM motors into a Dewalt transmission?
Quote:
|
|
#18
26-05-2008, 14:04
|
||||
|
||||
|
Re: How do you put 2 CIM motors into a Dewalt transmission?
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| pic: How do you put an encoder on the FP Gearbox? | JVN | Technical Discussion | 14 | 19-02-2007 22:00 |
| pic: Version 2 of the 2 CIM into 1 DeWalt gearbox | MAteo9944 | Extra Discussion | 3 | 21-01-2007 13:00 |
| How many CIM motors can we use? | lucky | Motors | 4 | 19-01-2006 18:30 |
| How much time do you put into building your robot | Wayne Doenges | General Forum | 16 | 29-01-2002 19:30 |
Linear Mode
