|
|
|
![]() |
|
|||||||
|
||||||||
| View Poll Results: Do you like Dewalts or Andymark Supershifter better? | |||
| Dewalts |
|
6 | 28.57% |
| SuperShifters |
|
15 | 71.43% |
| Voters: 21. You may not vote on this poll | |||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
Re: official dewalt thread
You can go to this thread on CD, post #14, on our mods for the DeWalt transmission, supplementing Joe Johnsons NBD white paper.
http://www.chiefdelphi.com/forums/sh...threadid=67769 We turn down a 3/4 steel shaft to 3/8, leaving a 1 inch long full diameter, which we thread internally onto the threaded end of the DeWalt tranny. It is pinned with a 1/8 hardened pin, retained with safety wire, to prevent it from loosening. fI have some pics that I can EMail to you, if you want. The mount consists of 4 plates, and one base plate. Plate 1 supports the end of the shaft extension, Plate 2 locks the boss of the DeWalt housing, plate 3 accepts the spacer ring and 4 screws to retain the transmission and adapt the CIM, and plate 4 supports the end of the CIM motor. We remove the anti-backdrive pins, clutch mechanism and adjustment ring, as well as speed shifter springs. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SCRRF Fall Classic Official Thread | ChrisH | Off-Season Events | 30 | 04-10-2007 23:56 |
| Official 2005 Clue Thread | MikeDubreuil | Rumor Mill | 586 | 30-01-2005 11:35 |
| Official Sensor/GUI Link Thread | Tom Bottiglieri | Programming | 19 | 19-01-2005 22:06 |
| The Official Halo 2 Thread | Joe Matt | Chit-Chat | 35 | 18-11-2004 23:47 |
| GALI-LEO! Official Thread | Joe Matt | Championship Event | 38 | 08-04-2004 17:47 |