|
|
|
 ...after all these years Dean is still on message, and the message still resonates. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| ...after all these years Dean is still on message, and the message still resonates. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#4
29-05-2008, 15:56
|
||||
|
||||
|
Re: AndyMark Wheels- adding sprockets, bolts, and such
I attached a screenshot of one of the wheels. It currently has a bearing and sprocket mated to the wheel. The bearing is fully defined, the sprocket n be moved closer to the wheel or farther away from the wheel, but the holes remain lined up.
I've also been trying to figure out if the KOP came with standoffs or spacers for the sprocket/wheel assembly... can't remember off the top of my head... If I have to, I may just cad all the nuts and bolts by hand, but if there's an easier way, I would much rather do it that way. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Different sprockets on front and back wheels | neoshaakti | Technical Discussion | 10 | 31-01-2008 17:52 |
| Extra gearboxes needed, KOP sprockets and wheels available in Suffolk County, NY | dmlawrence | Kit & Additional Hardware | 2 | 07-01-2008 10:24 |
| Friction coefficients for Omni wheels and Mecanum wheels from AndyMark | Andy Baker | Technical Discussion | 11 | 16-12-2006 19:40 |
| [OCCRA]: question about IFI wheels and sprockets | Russ C | OCCRA Q&A | 1 | 30-09-2006 14:13 |
| Are bolts to hold wheels on, and bearings, considered "fasteners"? | kmcclary | Off-Season Events | 3 | 22-10-2001 23:35 |
Threaded Mode