|
|
|
 People don't have to "get" it. They just have to know about it. Once they know about it, then they come to it, experience it, talk to it, learn it, then get it. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#8
29-05-2008, 17:39
|
||||
|
||||
|
Re: AndyMark Wheels- adding sprockets, bolts, and such
That works, I was just trying to figure out if there was a way to change the mate from the dimension.
Anyways, I guess I edited my message after you replied- The holes to connect the sprocket and wheel hub are different sizes ((sprocket is larger). I decided I could still use the right size bolts by selecting the holes on the wheel hub for the smart fastener, but it wont let me select those holes in the smart fastener dialog...How do I make this work? As for length, if I select a different bolt size, I can get the bolt long enough, but the bolt is too large in diameter for the holes. What do you guys do when adding bolts to the sprocket/wheel assemblies? Am I just doing this a hard way? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Different sprockets on front and back wheels | neoshaakti | Technical Discussion | 10 | 31-01-2008 17:52 |
| Extra gearboxes needed, KOP sprockets and wheels available in Suffolk County, NY | dmlawrence | Kit & Additional Hardware | 2 | 07-01-2008 10:24 |
| Friction coefficients for Omni wheels and Mecanum wheels from AndyMark | Andy Baker | Technical Discussion | 11 | 16-12-2006 19:40 |
| [OCCRA]: question about IFI wheels and sprockets | Russ C | OCCRA Q&A | 1 | 30-09-2006 14:13 |
| Are bolts to hold wheels on, and bearings, considered "fasteners"? | kmcclary | Off-Season Events | 3 | 22-10-2001 23:35 |
Threaded Mode