|
|
|
 Remember: This is High School Competition. - rich2202 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember: This is High School Competition. - rich2202 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
31-05-2008, 22:27
|
|||
|
|||
|
Re: Calibrating Devantech cmps03
We are connecting pins 1, 2, and 3 to +5v. Pins 6 and 9 are wired together and are connected to ground. Pin 4 is connected to the white pwm wire.
And yes, we are following those instructions. Basically, we point the compass north, connect and disconnect pin 6 (calibrate) to ground (pin 9, 0v). Then we repeat for the other three directions. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Devantech CMPS03 compass sensor | eagleslg | Programming | 1 | 24-05-2008 22:00 |
| Deventeh Digatal - CMPS03 - Robot Compass Module | kE7JLM | Programming | 5 | 08-11-2007 19:08 |
| Programming a Devantech Magnetic Compass - CMPS03 | kE7JLM | Programming | 7 | 28-09-2007 08:23 |
| calibrating a cmucam2 | muy dificil | Programming | 2 | 19-09-2005 12:46 |
| Calibrating Victors | SpaceOsc | Control System | 27 | 19-11-2004 07:59 |
Threaded Mode