|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: Evolution of a Gearbox: rev 7 exploded
That is one pretty design.
How much does it way? |
|
#2
|
||||
|
||||
|
Re: pic: Evolution of a Gearbox: rev 7 exploded
how does your design go into the DeWalt? would you all be making/buying a shaft and a gear to fit inside? how much effort are you expecting on the DeWalt alone?
having 0 hands-on experience with the DeWalt gearbox I am somewhat clueless. |
|
#3
|
||||
|
||||
|
Re: pic: Evolution of a Gearbox: rev 7 exploded
a 3/8 keyed shaft will enter the gearbox and interface with the 2nd planetary via a plate that slides over the carrier plate pins (like this) then that shaft will exit dewalt and be supported by two bearings. the gear attaches to that shaft.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Evolution of a gearbox rev 4 | roboticWanderor | Extra Discussion | 9 | 27-05-2008 09:19 |
| Exploded view of FP gearbox? | VEN | Technical Discussion | 1 | 13-03-2008 21:35 |