MasterCam Posting - Chief Delphi

I know FIRST is all about changing society. But my approach is one person at a time. - Phil 33 [more]

		Chief Delphi > Old Forum Archives > 2001
MasterCam Posting

View First Unread

Thread Tools

Rate Thread

Display Modes

23-06-2002, 22:05

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

MasterCam Posting

Posted by Steve Prairie at 12/19/2000 10:13 AM EST

Student on team #173, RAGE, from Rockville High School /East Hartford High School and UTRC.

Has anyone had experience posting Mastercam v8 to Light or Dyna milling machines? If so, can I contact you about some questions and problems I have?

Thanks

Steve Prairie
RAGE #173

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NO posting at disney site	archiver	2000	1	23-06-2002 22:15
Please start posting comments/suggestions	Ken Leung	CD Forum Support	9	06-05-2002 16:57
quality of posting...	David Kelly	CD Forum Support	3	12-02-2002 11:57
Why don't people start posting?	Ken Leung	General Forum	22	01-12-2001 01:27
posting...	David Kelly	Chit-Chat	3	09-11-2001 21:59

All times are GMT -5. The time now is 07:18.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.