pic: Madtown Robotics Future Frame Proto 1

[R.C.]

Our 2006 robot came back from Nationals and the 80/20 material was all bent up and the bot looked as if it had fallen off a roof top or something

[AdamHeard]

The scale just doesn't look right at all to me..... If the sides are 4x4, those motors look much smaller than small CIMs

[R.C.]

i got the drawing for the cims and the gearbox from a team at a regional, it is a dewalt setup.

[AdamHeard]

Originally Posted by rc_cola1323

i got the drawing for the cims and the gearbox from a team at a regional, it is a dewalt setup.

Hmmm.... I am 100% sure that those aren't CIMs w/ dewalt xrp gearboxes.

I don't know for sure, but I think those might be older drill motors from the KOP a long time ago.

I would go with Hachiban's recommendation and download from firstcadlibrary.

[EricH]

Originally Posted by AdamHeard

Hmmm.... I am 100% sure that those aren't CIMs w/ dewalt xrp gearboxes.

I don't know for sure, but I think those might be older drill motors from the KOP a long time ago.

I would go with Hachiban's recommendation and download from firstcadlibrary.

I'm with Adam on this. Those are 100% not CIMs, definitely not DeWalts either. They sure look like they could be the old drills, or maybe FPs. Odd mounting method, though it would make sense if you were going for cantilever (which you don't want here).

[R.C.]

For the wheels I meant http://www.omniwheel.com/cgi-bin/plu...de=Transwheel4 I'll ask team 418, thanks.