|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||||
|
||||||
|
Re: Arbor Press Specifications
Quote:
These tasks are done on the AndyMark arbor press: Press bearings into press-fit holes in plates, wheels, and gears Press dowel pins into holes (today was AM Planetary day) Swedge (is that a word?) over bore holes in AM Omni Wheels so that the bearing stays in better Press in PEM nuts into Super Shifter side plates Press in roll pins into Toughbox shaft holes that are drilled too small Oh, and we broach a few things also Don't get a 1 ton press... it is not big enough. Get a 3 ton press, like the one here at Northern Tool. I see the ones with a ratchet, but I don't think that is needed for these uses. A 2 ton press may be big enough, but probably not for a 1/2" broach. A good arbor press is your friend. Andy |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Teams forming in Ann Arbor, MI - YOUR HELP NEEDED! | kmcclary | General Forum | 5 | 09-09-2008 18:21 |
| Field Rug Specifications | MaddyW | Rules/Strategy | 1 | 21-01-2006 17:44 |
| Specifications | TechnocratiK | Programming | 2 | 14-12-2005 16:48 |
| Ann Arbor Area? | David66 | Chit-Chat | 2 | 02-03-2004 13:49 |
| Dashboard Interface Specifications | archiver | 2000 | 11 | 23-06-2002 22:43 |