|
|
|
 We are here to educate, inspire, and mentor not only the students, but teams who need guidance, whether they know it or not. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We are here to educate, inspire, and mentor not only the students, but teams who need guidance, whether they know it or not. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
17-06-2008, 19:25
|
||||
|
||||
|
Re: Help Programming a Quadrature Encoder
http://www.killerbees33.com/index.ph...d=27&Itemid=50
This is a link to some of Jim Z's programming tips. If your robot is slicing one way or the other, wheel encoders may help, but you can also use a gyro and have it adjust to keep a 0 heading. Sorry I am not a programmer, but hopefully some of Jim's stuff might help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quadrature shaft encoder source | billbo911 | Kit & Additional Hardware | 7 | 06-01-2008 19:52 |
| Encoder help | E_Unit | Electrical | 5 | 16-02-2007 11:02 |
| Turning a gear-tooth sensor into a quadrature output encoder | Jared Russell | Programming | 4 | 18-01-2006 22:19 |
| Encoder help | Windward | Programming | 21 | 14-01-2006 15:10 |
| shaft encoder help | stephenthe1 | Programming | 2 | 03-12-2004 16:09 |
Threaded Mode