24v selenoid valve

Tytus Gerrish · #1 09-07-2008, 09:23

shure!. just go to your local radio shack and pick up a 12v relay, create a 24v power source, an easy way is to buy a few AA battery holders. and use the relay to turn the power on and off to your 24v solenoid

Tottanka · #2 09-07-2008, 09:26

Quote:

Originally Posted by Tytus Gerrish

shure!. just go to your local radio shack and pick up a 12v relay, create a 24v power source, an easy way is to buy a few AA battery holders. and use the relay to turn the power on and off to your 24v solenoid

So i have ti plug in the outputs of the spike to this relay.
The only difference between the 2 solenoids is the voltage they work with, nothing else?

RyanN · #3 09-07-2008, 09:35

Yep, the only difference is the voltage.

16 AA batteries should work fine. (1.5V * 16 = 24V)

Mark McLeod · #4 09-07-2008, 12:47

If they aren't physically damaged the 12v coils on the broken solenoid can be removed (2 screws) and used to replace the 24v coils on the KOP solenoid. They are modular.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Victor 883 24v	normaldotcom	Control System	4	02-01-2008 17:21
Re-wiring 24V double solenoids	almsfan21	Pneumatics	2	30-01-2007 14:35
Old 883= 24V Speed controller???	stealth13777	Electrical	17	21-07-2005 12:45
Using SMC Single Selenoid Valve from last year?	Sachiel7	Pneumatics	3	20-01-2005 21:31
24v Motors, run on 12v?	Jacob Morgan	Electrical	26	01-01-2004 23:11