|
|
|
 Hmmm I think I hear phones ringing. Panic calls to the Rules committee to figure out how to close THAT loophole, which you could drive a truck through. Have you considered a career in Law? - ChrisH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
22-07-2008, 00:52
|
|||||
|
|||||
|
Re: pic: Spotted at IRI: New AM wheel (2)
I was gonna say, that sure looks like a 3d printer model....
Nice wheel! probably a 1-1/8" counter bore for the bearing, with a 7/8" hole size so you can use either 3/8" or 1/2" ID standard bearings. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Spotted in my new Make:... | Billfred | Extra Discussion | 10 | 27-03-2008 15:19 |
| pic: New wheel CAD | CraigHickman | Extra Discussion | 9 | 02-01-2008 20:29 |
| pic: New wheel CAD | CraigHickman | Extra Discussion | 4 | 08-09-2007 01:29 |
| pic: my new wheel design | hockeystud91 | Extra Discussion | 9 | 20-02-2007 19:18 |
| Segway spotted @ Loudon New Hampshire | mtaman02 | Dean Kamen's Inventions | 6 | 17-09-2002 17:37 |
Threaded Mode