|
|
|
 There is almost always more than one solution to any engineering problem. One part of elegant design is picking the one that makes the most sense for a particular design problem, even if that means "breaking" some normally established "rules". - Jeff Pahl [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
SolidWorks 2008
I have gotten used to using SolidWorks 2008 at work and have some parts that I have made in SW2008. However, on the computers we have for robotics we only have SolidWorks 2007. Does anyone know if we can get free copies of 2008?
Chris 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SolidWorks vs. Inventor | sanddrag | Inventor | 48 | 22-09-2008 22:57 |
| SolidWorks | Mike Martus | SolidWorks | 19 | 01-02-2006 21:55 |
| SolidWorks Book | Jeff Waegelin | Inventor | 2 | 15-06-2005 18:38 |
| Solidworks | sburro | General Forum | 7 | 14-10-2004 20:11 |
| Solidworks | edomus | General Forum | 1 | 11-12-2003 00:10 |
Threaded Mode